Xerox Phaser 3300MFP - Manual (Page 99)

15.2
6 Push the DIMM straight into the DIMM slot until it snaps into place.
Make sure the latches fit over the notches located on either side of
the DIMM.
7 Replace the control board cover.
8 Reconnect the power cord and printer cable, and turn the machine
on.
Activating the added memory in the PS printer
properties
After installing the memory DIMM, you need to select it in the printer
properties of the PostScript printer driver so that you can use it.
1 Make sure that the PostScript printer driver is installed on your
computer. For details about installing the PS printer driver, see the
Software Section.
2 Click the Windows Start menu.
3 For Windows 2000, select Settings and then Printers.
For Windows XP/2003, select Printers and Faxes.
For Windows Vista, select Control Panel > Hardware and Sound
> Printers.
4 Select the PS printer.
5 Click the right mouse button on the machine icon and select
Properties.
6 For Windows 2000/XP/2003/Vista, select Device Settings.
7 Select the amount of memory you installed from Printer Memory in
the Installable Options section.
8 Click OK.