Xerox Phaser 3300MFP - Manual (Page 9)

iv
Regulatory Information
CE Mark
The CE mark applied to this product, symbolizes XEROX's
declaration of conformity with the following applicable European
Union Directives, as of the dates indicated:
December 12, 2006:
Council Directive 2006/95/EC as amended. Approximation of the
laws of the member states related to low voltage equipment.
December 15, 2004:
Council Directive 2004/108/EC as amended. Approximation of the
laws of the member states related to electromagnetic compatibility.
March 9, 1999:
Council Directive 99/5/EC, on radio equipment and
telecommunications terminal equipment and the mutual recognition
of the conformity.
A full declaration of conformity, defining the relevant directives and
referenced standards, can be obtained from your XEROX Limited
representative.
WARNING: In order to allow this equipment to
operate in proximity to Industrial Scientific and
Medical (ISM) equipment, the external radiation from
the ISM equipment may have to be limited or special
mitigation measures taken.
NOTE: Changes or modifications to this equipment not specifically
approved by the Xerox Corporation may void the user’s authority to
operate this equipment.
WARNING: Shielded cables must be used with this
equipment to maintain compliance with Council
Directive 2004/108/EC.
EMC Information
FCC Notices For The USA
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications to this equipment not specifically
approved by the Xerox Corporation may void the user's authority to
operate this equipment.
EME Compliance for Canada
This Class "B" digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe "B" est conforme a la norme
NMB-003 du Canada.
WARNING: Shielded cables must be used with this
equipment to maintain compliance with FCC
regulations.