USRobotics Instant802 APSDK - Manual (Page 93)

Professional Access Point
Administrator Guide
Ethernet (Wired) Settings - 93
page 125.
Configuring Internal Interface Ethernet Settings
To configure Ethernet (Wired) settings for the Internal LAN, fill in the fields as described below.
Field Description
Virtual Wireless Networks
(Using VLANs on Ethernet Port)
• Select Enabled to enable VLANs for the Internal network and for
additional networks. If you choose this option, you can run the Internal
network on a VLAN whether or not you have Guest Access configured
and you can set up additional networks on VLANs using the Advanced
menu’s Virtual Wireless Networks page as described in “Virtual Wireless
Networks” on page 125.
• Select Disabled to disable the VLAN for the Internal network, and for any
additional virtual networks on this access point.
Field Description
MAC Address Shows the MAC address for the Internal network interface for the LAN port on this
access point. This is a read-only field.
VLAN ID If you choose to configure Internal and Guest networks by VLANs, this field is ena-
bled.
Provide a number between 1 and 4094 for the Internal VLAN.
This will cause the access point to send DHCP requests with the VLAN tag. The
switch and the DHCP server must support
VLAN IEEE 802.1Q frames. The access
point must be able to reach the DHCP server.