USRobotics Instant802 APSDK - Manual (Page 208)

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 208
Get Summary View of Internal and Guest Interfaces
USR5453-AP# get bss
name status radio beacon-interface mac
--------------------------------------------------------------------
wlan0bssInternal up wlan0 wlan0 00:0C:41:16:DF:A6
wlan0bssGuest down wlan0 wlan0guest
Get the DNS Name
USR5453-AP# get host id
USR5453-AP
Set the DNS Name
USR5453-AP# set host id vicky-ap
bob# get host id
vicky-ap
Get Wired Internal Interface Settings
See “Get Current Settings for the Ethernet (Wired) Internal Interface” on page 200 under Status .
Get Wired Guest Interface Settings
See “Get Current Settings for the Ethernet (Wired) Guest Interface” on page 201 under Status .
Set Up Guest Access
Configuring a Guest interface from the CLI is a complex task. Unless this is your area of expertise, you
may find it easier to use the Web User Interface to set up Guest Access. For information on how to set up
Guest Access from the Web User Interface, see
“Ethernet (Wired) Settings” on page 89 and “Guest Login”
on page 121 .
Before configuring guest or internal interface settings, make sure you are familiar the names of the
Set DNS Nameservers to Use Static IP Addresses (Dynamic to
Manual Mode) See example below.
Set DNS Nameservers to Use DHCP IP Addressing (Manual to
Dynamic Mode) See example below.
Note
Before configuring this feature, make sure you are familiar with the names of the interfaces as
described in
“Understanding Interfaces as Presented in the CLI” on page 190 . The interface name you
reference in a command determines whether a setting applies to a wired or wireless interface or to the
Internal or Guest network.
Wired Interface Command Example