USRobotics Instant802 APSDK - Manual (Page 195)

Professional Access Point
Administrator Guide
Class Structure, Commands, and Examples - 195
Get the Firmware Version for the Access Point
In the following example, the access point is running Firmware Version: 1.0.0.9. Use the get command as
shown to obtain the Firmware Version.
USR5453-AP# get system version
1.0.0.9
Get the Location of the Access Point
In the following example, the location of the access point has not been set. Use the get command as
shown to obtain the location of the access point.
USR5453-AP# get cluster location
not set
Set the Location for an Access Point
To set the location for an access point, use the set command as follows:
USR5453-AP# set system location hallway
USR5453-AP# set system location "Vicky's Office"
To check to make sure that the location was set properly, use the get command again to find out the
location
USR5453-AP# get system location
Vicky’s Office
Get the Current Password
USR5453-AP# get system encrypted-password
2yn.4fvaTgedM
Set the Password
USR5453-AP# set system password admin
USR5453-AP# get system encrypted-password
/rYSvxS4Okptc
Get the Wireless Network Name (SSID)
USR5453-AP# get interface wlan0 ssid
Internal Instant802 Network
Set the Wireless Network Name (SSID)
USR5453-AP# set interface wlan0 ssid "Vicky’s AP"
USR5453-AP# get interface wlan0 ssid
Vicky’s AP