Tektronix AFG3000 - Manual (Page 200)

Status and Events
4-16 AFG3000 Series Arbitrary/Function Generators Reference Manual
User Request Events These events are not used in this instrument.
Request Control Events These events are not used in this instrument.
Operation Complete
Events
These events occur when instrument’s synchronization protocol, having been
enabled by an *OPC command, completes all selected pending operations.
Table 4-11: User request events
Event code Event message
–600 User request
Table 4-12: Request control events
Event code Event message
–700 Request control
Table 4-13: Operation complete events
Event code Event message
–800 Operation complete