Tektronix AFG3000 - Manual (Page 129)

Syntax and Commands
AFG3000 Series Arbitrary/Function Generators Reference Manual 3-55
[SOURce[1|2]]:FREQuency:STOP
This command sets or queries the start frequency of sweep for the specified
channel. This command is always used with the
[SOURce[1|2]]:FREQuency:STARt command. The setting range of stop
frequency depends on the waveform selected for sweep.
Group Source
Related Commands [SOURce[1|2]]:FREQuency:MODE
[SOURce[1|2]]:FREQuency:STARt
Syntax [SOURce[1|2]]:FREQuency:STOP {|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:STOP? {MINimum|MAXimum}
Arguments ::=[]
where
is the stop frequency.
::=[Hz | kHz | MHz]
Returns
Examples SOURce1:FREQuency:STOP 100KHz
sets the stop frequency of CH 1 to 100 kHz.