Tektronix AFG3000 - Manual (Page 123)

Syntax and Commands
AFG3000 Series Arbitrary/Function Generators Reference Manual 3-49
[SOURce[1|2]]:FM:STATe
This command enables or disables FM modulation. The query command returns
the state of FM modulation.
Group Source
Syntax [SOURce[1|2]]:FM:STATe {ON|OFF|}
[SOURce[1|2]]:FM:STATe?
Arguments ON or
≠0 enables FM modulation.
OFF or =0 disables FM modulation.
Returns
Examples SOURce1:FM:STATe ON
enables the CH 1 FM modulation.
[SOURce[1|2]]:FREQuency:CENTer
This command sets or queries the center frequency of sweep for the specified
channel. This command is always used with the
[SOURce[1|2]]:FREQuency:SPAN command. The setting range of center
frequency depends on the waveform selected for sweep.
Group Source
Related Commands [SOURce[1|2]]:FREQuency:SPAN
[SOURce[1|2]]:FREQuency:MODE
Syntax [SOURce[1|2]]:FREQuency:CENTer {|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:CENTer?
Arguments ::=[]
where
is the center frequency.
::=[Hz | kHz | MHz]
Returns
Examples SOURce1:FREQuency:CENTer 550kHz
sets the CH 1 center frequency to 550 kHz.