Tektronix AFG3000 - Manual (Page 128)

Syntax and Commands
3-54 AFG3000 Series Arbitrary/Function Generators Reference Manual
[SOURce[1|2]]:FREQuency:STARt
This command sets or queries the start frequency of sweep for the specified
channel. This command is always used with the
[SOURce[1|2]]:FREQuency:STOP command. The setting range of start frequency
depends on the waveform selected for sweep.
Group Source
Related Commands [SOURce[1|2]]:FREQuency:MODE
[SOURce[1|2]]:FREQuency:STOP
Syntax [SOURce[1|2]]:FREQuency:STARt {|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency:STARt? {MINimum|MAXimum}
Arguments ::=[]
where
is the start frequency.
::=[Hz | kHz | MHz]
Returns
Examples SOURce1:FREQuency:STARt 10kHz
sets the sweep start frequency of CH 1 to 10 kHz.