Texas Instruments MSP50C6xx - Manual (Page 72)

I/O
3-8
A summary of the interrupts is given in Table 3–1.
Table 3–1. Interrupts
Interrupt Vector Source Trigger Event Priority Comment
INT0 0x7FF0 DAC Timer Timer underflow Highest Used to synch. speech data
INT1 0x7FF1 TIMER1 Timer underflow 2 nd
INT2 0x7FF2 TIMER2 Timer underflow 3 rd
INT3 0x7FF3 PD
2
Rising edge 4 th Port D
2
goes high
INT4 0x7FF4 PD
3
Falling edge 5 th Port D
3
goes low
INT5 † 0x7FF5 All port F Any falling edge 6 th Any F port pin goes from all-high to low
INT6 ‡ 0x7FF6 PD
4
Rising edge 7 th Port D
4
goes high
INT7 ‡ 0x7FF7 PD
5
Falling edge Lowest Port D
5
goes low
† All F port pins must be high previous to one or more going low.
‡ INT6 and INT7 may be associated with the Comparator function, if the Comparator Enable bit has been set.
Note: Interrupts in Reduced Power Mode
An interrupt may be lost if its event occurs during power-up or wake-up from
a reduced power mode. Also, note that interrupts are generated as a divided
signal from the master clock. The frequency of the various timer interrupts
will therefore vary, depending upon the operating master clock frequency.