Common cursors – Texas Instruments TI-86 User Manual
Page 34
22
Chapter 1: Operating the TI
-86
01OPER.DOC TI-86, Chap 1, US English Bob Fedorisko Revised: 02/13/01 2:18 PM Printed: 02/13/01 2:59 PM Page 22 of 22
01OPER.DOC TI-86, Chap 1, US English Bob Fedorisko Revised: 02/13/01 2:18 PM Printed: 02/13/01 2:59 PM Page 22 of 22
♦
To switch from alpha-lock to ALPHA-lock, press 1.
You can use - when ALPHA-lock or alpha-lock is on. Also, if you press a key that has no
blue character above it, such as 6, 3, or !, the key’s primary function still applies.
Common Cursors
Entry
Å
Enters a character at the cursor, overwriting any existing character
Insert
__
Inserts a character at the cursor location and shifts remaining characters right
Second
Æ
Enters a 2nd character or executes a 2nd operation (yellow on the keyboard)
ALPHA
³
Enters an uppercase ALPHA character (blue on the keyboard)
alpha
Ï
Enters the lowercase version of an ALPHA character (blue on the keyboard)
Full
Ä
Accepts no data; maximum characters are entered at a prompt or memory is full
♦
If you press 1 after - p, the cursor becomes an underlined
A
(
A
).
♦
If you press - 1 after - p, the cursor becomes an underlined
a
(
a
).
♦
If you press - after - p, the insert cursor becomes an underlined
# (
#
).
In most cases, the
appearance of the cursor
indicates what will happen
when you press the next key.
Graphs and editors
sometimes use additional
cursors, which are described
in other chapters.