beautypg.com

Initiating a memory backup, Selecting variables to send – Texas Instruments TI-86 User Manual

Page 249

background image

Chapter 18: The TI

-86 Communication Link

237

18LINK.DOC TI-86, Chap 18, US English Bob Fedorisko Revised: 02/13/01 2:40 PM Printed: 02/13/01 3:05 PM Page 237 of 10

18LINK.DOC TI-86, Chap 18, US English Bob Fedorisko Revised: 02/13/01 2:40 PM Printed: 02/13/01 3:05 PM Page 237 of 10

Initiating a Memory Backup

To initiate a memory backup, select

BCKUP

from the

LINK

SEND

menu (- o & &). The screen to the right is

displayed.

To complete memory backup, prepare the other unit to
receive data transmission (page 239), and then select

XMIT

from the memory backup menu (&).

Warning:

When you transmit

BCKUP

, the transmitted memory overwrites all memory in

the receiving unit; all information in the memory of the receiving unit is lost. To cancel
initiation of a memory backup, press ..

As a safety check to prevent accidental loss of memory,
when the receiving calculator is notified of an incoming
backup transmission, it displays the warning message and
confirmation menu, as shown in the screen to the right.

To continue the backup transmission, select

CONT

.

The backup transmission continues, replacing all
receiving-calculator memory with the backup data.

To cancel backup and retain all receiving-calculator memory, select

EXIT

.

Selecting Variables to Send

If a transmission error occurs
during a backup, the
receiving-calculator memory
is reset.

If no data of the type you
select is stored in memory,
the message is displayed:
NO VARS OF THIS TYPE

.