beautypg.com

Preparing to use your new ti-86, Installing the aaa batteries, Turning on and turning off the ti-86 – Texas Instruments TI-86 User Manual

Page 14: Adjusting the contrast

background image

2

Quick Start

00QWIKST.DOC TI-86, Quick Start, US English Bob Fedorisko Revised: 02/13/01 1:51 PM Printed: 02/13/01 2:59 PM Page 2 of 14

Preparing to Use Your New TI-86

The brief examples in the TI

-86 Quick Start demonstrate some common TI-86 features.

Before you begin, you must install the batteries, turn on the calculator, adjust the contrast,
and reset the memory and the defaults. Chapter 1 has more details on these topics.

Installing the AAA Batteries

Four AAA batteries are included in the TI

-86 retail package. Remove the batteries from the

package and install them in the battery compartment on the back of the calculator. Arrange
the batteries according to the polarity (+ and

N

) diagram in the battery compartment.

Turning On and Turning Off the TI-86

To turn on the TI

-86, press ^, which is in the bottom-left corner of the

keyboard. You should see the entry cursor ( Å ) blinking in the top-left
corner of the screen. If you do not see it, adjust the contrast (see below).

To turn off the calculator, press -, and then the key under

OFF

, which is

^. This guidebook uses brackets ( ã and ä ) to express - and 1
keystroke combinations. For example, to turn off the TI

-86, press - ž.

ON

1

0

ST

=

U

Y

RCL

BASE

CHAR

O

OFF

Adjusting the Contrast

ᕡ Press and release the yellow - key.
ᕢ Press and hold $ or # (above or below the half-shaded circle).

To darken the screen contrast, press and hold $.

To lighten the screen contrast, press and hold #.

EXIT

x-VAR

MORE

DEL

2nd

ALPHA

x

QUIT

alpha

LINK

INS

MODE

After about four minutes of
inactivity, the TI

-

86 turns off

automatically.

If you release

$

or

#

while

adjusting the contrast, you
must press

-

again to

continue the adjustment.