Texas Instruments TI-84 - Manual (Page 163)

Chapter 6: Sequence Graphing 160
nMin must be an integer | 0.
nMax , PlotStart , and PlotStep must be integers | 1.
nMin is the smallest n value to evaluate. nMin also is displayed in the sequence Y= editor.
nMax is the largest n value to evaluate. Sequences are evaluated at u(nMin) , u(nMin+1) ,
u(nMin+2) , ... , u(nMax) .
PlotStart is the first term to be plotted. PlotStart=1 begins plotting on the first term in the
sequence. If you want plotting to begin with the fifth term in a sequence, for example, set
PlotStart=5 . The first four terms are evaluated but are not plotted on the graph.
PlotStep is the incremental n value for graphing only. PlotStep does not affect sequence
evaluation; it only designates which points are plotted on the graph. If you specify
PlotStep=2 , the sequence is evaluated at each consecutive integer, but it is plotted on the
graph only at every other integer.
Xmax =10 Largest X value to be displayed
Xscl =1 Spacing between the X tick marks
Ymin = L10 Smallest Y value to be displayed
Ymax =10 Largest Y value to be displayed
Yscl =1 Spacing between the Y tick marks