Toshiba XLTR-200 - Manual (Page 9)

8
2. Feature Summary
RS485 Ports
Two half-duplex 2-wire RS485 ports (A / B / Signal Ground / Shield). These
ports allow a selection of various master and slave protocols.
RS232 Port
One RS232 port that can be used to configure the unit, update the internal
firmware, upload/download files or act as a control protocol port.
Toshiba ASD Ports
Three common serial (aka logic level) ports for connection of Toshiba 7-series,
9-series, 11-series or VF-nC1 ASDs. ASD connections use the same standard
RJ45 style 8-conductor UTP patch cables: any standard CAT5 Ethernet cable
(found in most electronics stores) 5 meters or less in length can be used. ASD
connections are automatically established and continuously monitored: no
drive configuration needs to be performed to connect the unit to the drives.
Just plug it in – it’s that simple.
Power Supply
When connected to Toshiba ASDs via the ASD1 / ASD2 / ASD3 ports, can be
either powered directly from the attached ASDs, or from the auxiliary power
(“AUX PWR”) input jack. All other non-Toshiba applications require the use of
the AUX PWR input to supply power to the unit. When more than one power
source is connected, the unit will draw its control power from the source with
the highest supply voltage.
Supported Protocols
Modbus RTU (RS485 master & slave)
Modbus RTU (RS232 master & slave)
Toshiba ASD (common serial master)
Toshiba ASD (RS485 master)
Toshiba 3-series ASD (RS232 master)
Mitsubishi 500-series & 700-series ASD (RS485 master) (also used by
MGI Technologies, Inc. ASDs)
Siemens FLN (RS485 slave)
Johnson Controls, Inc. Metasys N2 (RS485 slave)
New network drivers are continuously being added, and can be downloaded for
free from our web site.