Qualstar 501440 Rev. G - Manual (Page 19)

Fibre Channel Cable
To Host or Switch
Drive 1
Drive 2
Drive 3
Drive 4
Drive 5
Drive 6
Terminators
FCO
Executive PCBA
SCSI Channel 0
SCSI Channel 1
Figure 4-4 TLS-46xxx Cabling Diagram using AIT-3 Tape Drives
Connectors on Rear of FCO Connectors on Rear of TLS-46xxx
FCO: SCSI Channel 0 Medium Changer
Tape Drive 1 (T1)
Tape Drive 2 (T2)
Tape Drive 3 (T3)
FCO: SCSI Channel 1 Tape Drive 4 (T4)
Tape Drive 5 (T5)
Tape Drive 6 (T6)
FCO: Serial Jumper
Table 4-4 Preferred TLS-46xxx Fibre Channel Option Cable Connections for AIT-3 Tape Drives
4.4 Cabling for TLS-8000 and 88xxx Libraries
Prior to installing a Fibre Channel Option on TLS-8000 or 88xxx libraries the tape
drive assemblies may need to be installed in the library and the drives will need to be
cabled as shown in this section. Refer to the Installation section in the TLS-
5000/6000/8000 Installation and Operation Manual (Qualstar document number
501450 ) for details about tape drive assembly preparation, enabling SCSI termination
power and installation.
FCO Type C Installation
501440 Rev. J
4-6