Output Solutions 650 - Manual (Page 34)

Configuring the Printer
3.4.1 SELECT CURRENT MACRO
The printer stores up to three user settings in MACRO 1 up to MACRO 3.
Use the [STOP
#] key to activate this function. The active macro is displayed first. Press
the [COMPRESS –] key until you find the macro for your application and selected it with
the [STOP
#] key. The printer will save the selected macro immediately. After the
procedure the printer changes into the ON-LINE mode and will now work with the new
settings.
3.4.2 SELECT USER TO SETUP
With the module SELECT USER TO SET UP you have the choice between MACRO 1,
MACRO 2, and MACRO 3. Select the macro witch should be changed.
Note:
If you have selected all new items and have these confirmed with the [STOP ] key,
don't forget to activate the module SAVE PARAMETERS.
3.4.3 CONFIGURE
The following items can be modified according to the C-650 Plus
Note: In the different emulations the items shown are not equal. The option’s which are
printed in bold indicate the actual setting.
CONFIGURE
Parameter Option Explanation Note
RESUME DEFAULT VALUE NO
YES
Select resume default
value or not,
If select YES, jump to
SAVE PARAMETERS the
parameters will be resumed
the default value if pressing
[STOP ] to confirm. This option is mainly
used to resume the
default value when the
menu parameters
have been changed in
disorder.
INTERFACE DUAL
INTERFACE
SERIAL1
CX
Select the interface you
want to use. DUAL or CX will be
selected only if an
optional interface card
is installed.
RS1 EMULATION IBM
LQ1600K
Select your RS1 emulation
3-6