Ricoh Network Guide - Manual (Page 65)

Using NetWare
59
3
Using NetWare
This section describes the setting pro-
cedure for network printers in the
NetWare environment. In the Net-
Ware environment, you can connect
the machine as a “print server” or “re-
mote printer”.
❖ Setting procedure
• When using the machine as a
print server
A Installing SmartDeviceMon-
itor for Admin
B Setting the network interface
board.
C Turning the machine off and
then back on.
• When using the machine as a
remote printer
A Installing SmartDeviceMoni-
tor for Admin.
B Setting the network interface
board.
C Setting NetWare.
D Starting the print server.
Note
❒ This procedure assumes an envi-
ronment is already prepared for
normal NetWare running the
printing service setting.
❒ The procedure is explained with
the following example settings:
• File server’s name …CAREE
• Print server’s name …PSERV
• Printer’s name …R-PRN
• Queue name …R-QUEUE
❖ Using SmartDeviceMonitor for Admin
To use the machine in a NetWare
environment, use SmartDevice-
Monitor for Admin to set the Net-
Ware printing environment.
Note
❒ The NetWare Client provided
by Novell is required to set the
printing environment using
SmartDeviceMonitor for Ad-
min under the following envi-
ronments:
• NDS mode in Windows 95/
98/Me
• NDS or Bindery mode in Win-
dows 2000/XP, Windows NT
4.0
Reference
For details about installing
SmartDeviceMonitor for Ad-
min, see p.77 “Installing Smart-
DeviceMonitor for Admin”.
❖ Printers listed by SmartDeviceMoni-
tor for Admin
SmartDeviceMonitor for Admin
lists printers connected to the net-
work. If you cannot identify the
machine you want to configure,
print configuration page, and then
check the machine name.
Setting Up as a Print Server
(NetWare 3.x)
Follow the procedure below to con-
nect the machine as a print server us-
ing NetWare 3.x.
A
Log on to the file server as a su-
pervisor or supervisor equivalent.
B
Start NIB Setup Tool from the
[Start]
menu.
C
Click [Wizard], and then click [OK].
D
Select a machine you want to con-
figure.