Roland SD-50 - Manual (Page 84)

84
Driver Settings
fig.driver-e.eps
About the Items in the Settings Dialog Box
No. Setting Description
Audio Buffer Size
This lets you adjust the buffer size for the audio input/output. (The default setting is
the sixth position from the left.)
* If you change the buffer size, you must restart the application that’s using the SD-50,
or if you’re using an application that has an audio device test function, you must
execute that test function.
* Depending on the application that you’re using, its audio settings may also contain
a buffer size adjustment.
ASIO Buffer Size
This is the minimum buffer size that can be specified for an ASIO application.
* Depending on the application you’re using, there may be settings other than the
minimum buffer size, meaning that in some cases the buffer size shown here might
not match the actual buffer size.
For details on how to set and view the buffer size, refer to the owner’s manual for
your application.
Use Smaller ASIO Buffer Size
By selecting this check box, you can decrease the buffer size when using ASIO
compatible software.
If you experience dropouts in the sound with this check box selected, clear the check
box.
* Clear this check box if you want to adjust the Audio Buffer Size.
Use ASIO Direct Monitor
Select this check box if you want to use ASIO Direct Monitor functionality with your
ASIO compatible software.
Light Load
Normally, you should leave this check box cleared.
* A setting change will take effect after you’ve switched off the SD-50’s power, then
switched it back on again.
Show “README” Displays the README file.
Driver version This displays the version of the currently installed driver.
2
1
3
4
5
6
7
1
2
3
4
5
6
7
SD-50_e.book 84 ページ ２０１０年１月２５日 月曜日 午前１０時５２分