Roland SD-50 - Manual (Page 57)

57
Using the SD-50 as an Audio Interface
Adjust the input level
1. Press the [PART] button a number of times to access the audio part screen.
The level meters will appear.
page_audio_meter-mic.eps
2. Turn the [SENS] knob to adjust the input volume.
In order to record with the best audio quality, use the [SENS] knob to increase the level as far as possible without
allowing an overload to occur; i.e., don’t let the level meter reach the maximum point.
You can apply echo to the sound of the connected microphone or guitar (p. 59).
* If the indication below appears, the input level has overloaded even though the level meter did not reach the
maximum point.
fig.input-level-over.eps
1. Operate your computer to start recording.
For details on how to start recording, refer to the user’s guide for the software you’re using.
Recording
SD-50_e.book 57 ページ ２０１０年１月２５日 月曜日 午前１０時５２分