Roland SD-50 - Manual (Page 20)

20
Turning the Power On/Off
1. Connect the included AC adaptor and power cord.
2. Connect the AC adaptor to the DC In connector on the rear panel.
fig-connect-AC-Adaptor_e.eps
932
* Place the AC adaptor so the side with the indicator (see illustration) faces upwards and the side with textual
information faces downwards.
* The indicator will light when you plug the AC adaptor into an AC outlet.
1. Press the latches of the bottom panel battery compartment lid, and remove the lid.
fig.Battery-1.eps
• When opening the battery compartment cover, make sure that no foreign objects (flammable items, coins,
pins, etc.) or liquids (water, juice, etc.) enter the compartment.
928
• When turning the unit upside-down, get a bunch of newspapers or magazines, and place them under the
four corners or at both ends to prevent damage to the buttons and controls. Also, you should try to orient
the unit so no buttons or controls get damaged.
929
• When turning the unit upside-down, handle with care to avoid dropping it, or allowing it to fall or tip over.
Before You Turn the Power On
Using the AC Adaptor
Using Batteries
To an electrical outlet
Indicator
AC adaptor
Power cord
1
2
SD-50_e.book 20 ページ ２０１０年１月２５日 月曜日 午前１０時５２分