Clearing a personal code – NEC L320 User Manual
Page 86
Using the Operating System and Utilities 4-13
2.
Enter up to 5 button strokes for the password. Multiple buttons held down at the
same time represent a unique entry, independent of individual button strokes.
3.
Press the
Enter
button to set the password.
Note
The personal code can be up to 5 button strokes. Multiple buttons held down
at the same time represent a unique entry (independent of individual button strokes) —
allowing close to 800,000 personal code combinations.
Clearing a Personal Code
Follow these steps to clear a personal code.
T
To clear a User personal code:
—
Log on as the User with the personal code you want to change.
—
Press the
3
button and the
Enter
button at the same time and hold both down
for at least 5 seconds.
—
Enter the personal code to be cleared and press the
Enter
button.
Note
A User personal code can be cleared by the Supervisor, without the
Supervisor knowing the User personal code.
T
To clear a Supervisor personal code:
—
Log on as the Supervisor.
—
Press the
4
button and the
Enter
button at the same time and hold both down
for at least 5 seconds.
—
Enter the personal code to be cleared and press the
Enter
button.
T
To set a new personal code, see “Establishing a Personal Code.”
When the Supervisor or User personal code is being cleared or reset, the Security LED
flashes.
Note
If you forget your password (personal code), contact NEC Computers Support
Services for information about clearing it. See Chapter 11, “Getting Service and
Support,” for contact information.