NEC L320 - Manual (Page 136)

Using External Devices 8-9
Parallel Devices
To install a parallel device such as a printer, you need a cable with a male 25-pin
connector for the system and, for most parallel printers, a Centronics
®
-compatible
36-pin connector.
Note When you connect a printer, be sure to install the appropriate printer driver
through the Windows control panel.
Connect a parallel device to your NEC Versa as follows.
1. Check that power to both the NEC Versa and the device is off.
2. Align and connect the 25-pin parallel cable connector to the parallel port on the
system. Secure the cable with the screws provided.
3. Align and connect the other end of the cable to the parallel port on the device.
Lock the connector clips.
Connecting a parallel printer
4. Connect the power cable to the device and a properly grounded wall outlet.
5. Turn on power to the system and the device.
Note Check that the device is online before you try to use it. See the instructions
that came with the device for more information.