NEC L320 User Manual
Page 81
4-8 Using the Operating System and Utilities
2.
Select the PHDISK utility for installation. Follow the prompts to install the
appropriate files on your hard drive.
3.
Once the files have been installed, exit the Application and Driver CD interface
and remove the CD.
4.
Restart your system in MS-DOS mode by clicking Start and clicking Shut Down.
Select ‘Restart in MS-DOS mode’ and click
OK
.
5.
At the MS-DOS prompt, type
cd \necutils\phdisk
and press
Enter
to change to the
\necutils\phdisk directory.
6.
Type
phdisk
and press
Enter
. The PHDISK utility interface appears with the
following valid options:
1. Create Partition
2. Create File
3. Reboot
4. Exit
7.
Enter
2
and press
Enter
. (Be careful not to select Create Partition.) A prompt
similar to the following appears:
Please input size (Minimal: 74179) KB:
(The minimal size varies according to the amount of system memory installed in
your system.)
8.
Press
Enter
to accept the minimal size. A file large enough to accommodate your
system’s memory is created on the hard disk drive, and the PHDISK utility
interface appears again.
9.
Enter
3
(for Reboot) and press
Enter
.
10.
If necessary, press any keyboard key when prompted to reboot the system.
11.
When Windows 98 SE has restarted, click Start, click Settings, and click Control
Panel. Double click the Power Management icon.
12.
Click the Hibernate tab. Put a check in the box next to
Enable hibernate suppor
t
and click
Apply
.
13.
Select the Advanced Tab. The following settings now provide Hibernate as a
choice in their pull-down menus.
T
When I close the lid of my portable computer
T
When I press the power button on my computer
14.
Select Hibernate for either or both of these settings (if desired). Click
OK
to close
the Power Management Properties window.