NEC L320 - Manual (Page 85)

4-12 Using the Operating System and Utilities
See the following sections for procedures on establishing personal codes, clearing a
personal code, using a personal code to access the system, and using a personal code to
bring the system out of a power-saving state.
Identifying Personal Code Setting Buttons
The following figure shows the locations of the Personal Code Setting buttons on the
system. (Not all systems come with Personal Code Setting buttons.)
Locating Personal Code Setting buttons
A – Personal Code Button 1 E – Personal Code Enter Button
B – Personal Code Button 2 F – Shortcut Button
C – Personal Code Button 3 G – Power Button
D – Personal Code Button 4 H – Shortcut Button
Establishing Personal Codes
The Personal Code Setting utility can store a Supervisor personal code, and up to two
User personal codes. Follow these steps to establish a personal code.
1. Prepare to set the personal code:
T To set a User personal code for the first time, press the 1 button and the Enter
button at the same time and hold both down for at least 5 seconds.
T To set a Supervisor personal code for the first time, press the 2 button and the
Enter button the same time and hold both down for at least 5 seconds.
When the system is in Personal Code Input mode, the LED flashes.