NEC L320 - Manual (Page 100)

5-6 Using the System Drives and Bays
5. Grasp the edge of the NEC VersaBay IV device and pull the device out of the
system.
Removing a device from the VersaBay IV slot
Always install the weight-saving module that ships with your
system in the VersaBay IV slot if no VersaBay IV device is installed in the slot. See
“Installing a Device in the NEC VersaBay IV Slot” for instructions on installing the
module.
Installing a Device in the NEC VersaBay IV Slot
Use the following steps to install a device in the NEC VersaBay IV slot.
1. Use the Phoenix BaySwap utility or power off the system.
2. Remove the VersaBay IV device or weight-saving module from VersaBay IV slot.
3. Align the device in the NEC VersaBay IV slot and push it in until it fits securely
into the bay.