Hardware setup – NEC Disk Array Controller N8103-89 User Manual
Page 80

60
5. Hardware Setup
Install the disk array controller in a server in the following procedure.
Check
Before the installation, always refer to the User’s Guide of the server. The
job flow varies depending on the server type, system configuration, and
existence of additional HDD cage. Check the server type and device
configuration before the installation to follow the correct flow.
Start
setup
Prepare
for
setup.
Select and install bracket.
Install the disk array controller
(with connection of additional battery).
Connect LED and SATA cables.
Install additional HDD cage.(*)
Form
SATA
cable.
Connect
I2C
cable.(*)
End
setup.
(*) These steps are not required if the additional HDD cage is not installed.