Nortel Networks Mediant TP-1610 SIP - Manual (Page 138)

Mediant 2000 SIP
Mediant 2000 SIP User’s Manual 138 Document #: LTRT-72504
When the list of recorded files is converted to a single voiceprompts.dat file, every Voice Prompt
is tagged with an ID number, starting with “1”. This ID is used later by the Mediant 2000 to start
playing the correct announcement. Up to 1000 Voice Prompts can be used.
Note: The Voice Prompt ID is used in the VXML file to specify the message that is
to be played.
AudioCodes provides a professionally recorded English (U.S.) Voice Prompts file.
To generate and load the Voice Prompts file, take these 3 steps:
1. Prepare one or more voice files using standard utilities.
2. Use the TrunkPack Downloadable Conversion Utility to generate the voiceprompts.dat file
from the pre-recorded voice messages (refer to Section
G.1.2 on page 215 ).
3. Load the voiceprompts.dat file to the Mediant 2000 either by using a TFTP procedure (refer
to Section
6.12.1 on page 132 ), or via the Embedded Web Server (Section 5.11.2 on page
82 ).
7.4 CAS Protocol Configuration Files
The CAS Protocol Configuration Files contain the CAS Protocol definitions to be used for CAS-
terminated trunks, Users can either use the files supplied or construct their own files.
It is possible to load up to eight files and to use different files for different trunks.
Note that all CAS files loaded together must belong to the same Trunk Type (either E1 or T1).