Nortel Networks 450 - Manual (Page 279)

Default Settings
302401-D Rev 00 F-3
Unit 1 Port Configuration ( page 3-32 )
Status Enabled (for all ports)
Autonegotiation Enabled (for all ports )
Speed/Duplex 100Mbs/Half (when
Autonegotiation is Disabled)
Unit 1 to 8 (depending on
configuration status) High Speed Flow Control Configuration
(
page 3-34 )
Autonegotiation Enabled
Flow Control Disabled
Note: The following two fields only appear when a single Phy MDA with a separate redundant Phy port is
installed.
Preferred Phy Right
Active Phy Read-only field indicating the
operational Phy port (Right,
Left, or None)
Trunk Members (Unit/Port) Zero-length string MultiLink Trunk Configuration
( page 3-39 )
STP Learning Normal
Trunk Mode Basic
Trunk Status Enabled
Trunk Name Trunk #1 to Trunk #6
Traffic Type Rx and Tx MultiLink Trunk Utilization ( page 3-41 )
Monitoring Mode Disabled Port Mirroring Configuration
(
page 3-45 )
Monitor/Unit Port Zero-length string
Unit/Port X Zero-length string
Unit/Port Y Zero-length string
Address A 00-00-00-00-00-00
(no MAC address assigned)
Address B 00-00-00-00-00-00
(no MAC address assigned)
(continued)
Table F-1. Factory Default Settings for the BayStack 450 Switch (continued)
Field Default setting Appears in this CI screen
kombk.book Page 3 Tuesday, June 29, 1999 3:25 PM