Nortel Networks 450 - Manual (Page 165)

Using the Console Interface
302401-D Rev 00 3-33
Figure 3-14. Port Configuration Screen (2 of 2)
Table 3-12 describes the Port Configuration screen fields.
Note: When a gigabit MDA is installed, only the Status field for that MDA
port is configurable. See “High Speed Flow Control Configuration ” on
page 3-34 to set the autonegotiation field for the gigabit MDA port. Gigabit
MDAs only support 1000 Mb/s in full-duplex mode.
Table 3-12. Port Configuration Screen Fields
Field Description
Unit Allows you to select the unit number (when stacking is configured) to view or
configure. To view or configure another unit, type its unit number and press [Enter], or
press the spacebar to toggle the unit numbers.
(continued)
Port Configuration
Unit: [ 1 ]
Port Trunk Status Link Autonegotiation Speed Duplex
---- ----- ------------ ---- ---------------- -----------------
15 [ Enabled ] Up [ Enabled ] [ 10Mbs / Full ]
16 [ Enabled ] Down [ Disabled ] [ 10Mbs / Half ]
17 1 [ Enabled ] Up [ Disabled ] [ 10Mbs / Half ]
18 [ Enabled ] Down [ Disabled ] [ 10Mbs / Half ]
19 3 [ Enabled ] Up [ Disabled ] [ 10Mbs / Half ]
20 3 [ Enabled ] UP [ Disabled ] [ 10Mbs / Half ]
21 [ Enabled ] Down [ Disabled ] [ 10Mbs / Half ]
22 4 [ Enabled ] Up [ Enabled ] [ 10Mbs / Full ]
23 4 [ Enabled ] Up [ Enabled ] [ 10Mbs / Full ]
24 [ Enabled ] Down [ Enabled ] [ 10Mbs / Full ]
25 [ Enabled ] Up [ Enabled ] [ 100Mbs / Full ]
26 [ Enabled ] Up [ Enabled ] [ 100Mbs / Full ]
27 [ Enabled ] Down [ Disabled ] [ 100Mbs / Full ]
28 [ Enabled ] Down [ Disabled ] [ 100Mbs / Full ]
Switch [ Enable ] [ Enable ] [ 10Mbs / Half ]
Stack [ Enable ] [ Enable ] [ 10Mbs / Half ]
Press Ctrl-P to display choices for ports 1-14.
Use space bar to display choices, press or to select choice.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 33 Tuesday, June 29, 1999 3:25 PM