Nortel Networks 450 - Manual (Page 214)

Using the BayStack 450 10/100/1000 Series Switch
3-82 302401-D Rev 00
Configuration File
The Configuration File Download/Upload screen ( Figure 3-34 ) allows you to
store your switch/stack configuration parameters on a TFTP server.
You can retrieve the configuration parameters of a standalone switch or an entire
stack and use the retrieved parameters to automatically configure a replacement
switch or stack. Certain requirements apply when automatically configuring a
switch or stack using this feature (see
“Requirements ” on page 3-83 ). You must
set up the file on your TFTP server and set the filename read/write permission to
enabled before you can save the configuration paramenters.
Although most configuration parameters are saved to the configuration file,
certain parameters are not saved (see
Table 3-31 on page 3-84 ).
Choose Configuration File (or press g) from the main menu to open the
Configuration File Download/Upload screen.
Figure 3-34. Configuration File Download/Upload Screen
Table 3-30 describes the Configuration File Download/Upload screen fields.
Configuration File Download/Upload
Configuration Image Filename: [ ]
TFTP Server IP Address: [ 132.245.164.4 ]
Copy Configuration Image to Server: [ No ]
Retrieve Configuration Image from Server: [ No ]
Enter text, press or when complete.
Press Ctrl-R to return to previous menu. Press Ctrl-C to return to Main Menu.
kombk.book Page 82 Tuesday, June 29, 1999 3:25 PM