Verifying server2 (application server) – Nortel Networks Sun Fire V210 (RoHS) User Manual
Page 165
MCS 2-server Sun Fire V210 (RoHS) Solaris Installation and Commissioning Guide
165
Copyright © Nortel Networks Limited 2006
120.120.13.1
The only address in this file defines your default gateway route
(your router). If this file is empty and the machine is rebooted,
then you will not have network access to your other servers.
Verifying Server2 (application server)
The following commands are executed on the application server using
PuTTY SSH into the machine logical IP address.
Example: Open a PuTTY SSH session to 120.120.13.25
Procedure 44 Verifying the application servers
At the management pc,
1
Log into the server as nortel/
2
After installing the MCS Base Platform System Software CDs
1-6, execute the following command to verify IP addressing.
[@mcsmicroapp]/export/home/nortel:=> ifconfig -a
lo0:
flags=1000849
bge0:
flags=9040843
120.120.13.23 netmask ffffff00 broadcast 120.120.13.255
groupname imspub
bge0:1:
flags=1000843
broadcast 120.120.13.255
bge1:
flags=69040843
1500 index 3 inet 120.120.13.24 netmask ffffff00 broadcast
120.120.13.255 groupname imspub
3
Look for the entry that starts with ‘bge0.’ The parameters that
follow show the IP address, subnet mask, and whether the
interface is ‘UP.’ This example output shows that bge0 is
assigned to IP address 120.120.13.23, its subnet mask is ffffff00
which translates to 255.255.255.0, and the interface is UP
(active).