Patton electronic 3196RC User Manual
User manual
Table of contents
Document Outline
- Summary Table of Contents
- Table of Contents
- List of Figures
- List of Tables
- Compliance Information
- About this guide
- Chapter 1 Introduction
- Chapter 2 Hardware installation
- Introduction
- Unpacking the Model 3196RC T-DAC
- T-DAC blades installation
- Cable installation
- Completing the hardware installation
- Chapter 3 Configuring the T-DAC for operation
- Introduction
- Configuration prerequisites
- Initial configuration through the RS-232 control port
- Using a browser to complete Model 3196RC configuration
- Displaying the T-DAC 3196RC web administration pages
- Configuring the default gateway
- Configuring the system clocking parameters
- Configuring the DS0 mapping
- Activating the iDSL ports
- Configuring Patton iDSL CPE device remotely via the Model 3196RC
- Configuring line settings and signaling for E1
- Configuring the E1 line interface settings
- Configuring line settings and signaling for T1
- Saving your configuration
- Backing up your configuration parameters
- Completing the installation
- Chapter 4 Operation and shutdown
- Chapter 5 Troubleshooting and maintenance
- Chapter 6 Contacting Patton for assistance
- Appendix A Network Ports (RJ-21X) connector pin-out
- Appendix B WAN Network Module connector pinout