B.1.3.2 error states – PYLE Audio IKON RUGGED 7505-BTSDCMHC25 User Manual
Page 287
Appendix B: Wireless Wide Area Network (WWAN)
Advanced Information
Ikôn Rugged PDA (Windows CE 5.0) User Manual
B-7
•
Ready to connect.
If the modem loses the connection to the GSM network, the following states are repeated:
Searching for network, Registered on network, Searching for packet data, and Ready
to connect.
B.1.3.2 Error States
The following temporary error states (i.e., these states may disappear without interaction)
may be displayed:
•
Emergency calls only.
The modem has found a network but is not allowed to register (e.g. no roaming agree-
ment between networks). The modem keeps searching for another network.
•
No network found.
A network is not currently available. The modem continues searching for a network.
•
Packet data not available.
The current network does not support a packet data service.
•
Packet data not allowed.
The modem is not allowed to use the packet data service on the current network (e.g. no
GPRS roaming agreement between network; a roaming agreement for voice may still be
in place). It is also possible that you do not have a subscription for GPRS at all.
The remaining error states are permanent:
•
SIM is missing.
The SIM card is missing. After the SIM has been inserted a warm boot may be required.
•
SIM failure.
The SIM card is permanently disabled (e.g. because the wrong PUK has been entered
too many times). A new SIM is needed.
•
Modem failure.
The modem did not respond to commands as expected. If a warm boot does not clear
this condition, the modem may need to be replaced.
•
NDIS error.
An internal software error has occurred. If a warm boot does not clear this condition,
Psion Teklogix technical support may need to investigate further.