4 imager, 1 imager options, Imager options – PYLE Audio IKON RUGGED 7505-BTSDCMHC25 User Manual
Page 207
Ikôn Rugged PDA (Windows CE 5.0) User Manual
195
Chapter 5: Configuration
Imager
Imager Options
5.14.4 Imager
•
Tap on the Scanner drop-down menu, and choose Imager.
5.14.4.1
Imager Options
TekImager Enabled
Setting this option to on enables the imager installed in your Ikôn.
Continuous Scan Mode
Setting this parameter to on keeps image capture active and continuously decoding as long
as the scanner button is pressed and held down.
Center Bar Code Only
When more than one bar code is visible in a single snap shot, this parameter allows you to
specify that only the centre image within the imager framing marker be read. When this pa-
rameter is set to on, the target dot is pointed at the centre image and only that image
is returned.
Max Number Barcodes
This parameter specifies the maximum number of bar codes the imager will attempt to
decode in an image. A maximum of 6 bar codes can be decoded at one time.
Note: This parameter must be disabled when reading Composite bar codes.