PYLE Audio IKON RUGGED 7505-BTSDCMHC25 - Manual (Page 253)

Chapter 6: Peripheral Devices & Accessories
USB And Serial Connections
Ikôn Rugged PDA (Windows CE 5.0) User Manual 241
- It is preferable to wire after the key switch. In this configuration, when the key is
turned ON, the vehicle will power the cradle and docked Ikôn, charging the internal
battery when needed. When the vehicle ignition is OFF, the Ikôn docked in the cradle
will run on its internal battery.
- However, if the operator switches the key off repeatedly for long periods during a
shift, it may make more sense to wire the vehicle cradle before the switch. In this
case, the Ikôn will always operate from vehicle power and that power will charge the
battery when needed.
- Keep in mind that the Ikôn will continue to operate with or without vehicle power as
long as the internal battery has sufficient charge.
6.10.4 USB And Serial Connections
The Powered Vehicle Cradle full configuration consists of two serial DE-9M ports and one
USB Type A port located at the base of the product. These are COM and USB ports that
allow the communication of serial and USB devices with the Ikôn. These ports are:
•
One powered USB A (Host).
• One full Serial port.
• One Serial port that provides power over pin 9. This port is located nearest the front
LED and is marked as COM 6 in Figure 6.15.
Figure 6.15 CH1005A Ports
Important: Depending on the configuration, the CH1005A Powered Vehicle Cradle
has up to three data connectors and one power connector.
Serial Port B
Serial Port A
USB A (Host)
Port
DC Power Port
(COM 5)
(COM 6)