Paradyne 3910 - Manual (Page 65)

DCP Configuration
5-3 3910-A2-GN32-40 September 1998
Active (Saved)
(ATZ0, ATZ3)
Customer1
(ATZ1)
Customer2
(ATZ2)
Factory
USE AT&W COMMAND TO SAVE
CHANGES TO Active (Saved),
Customer1, OR Customer2
LOAD Active (Operating)
USING ATZ OR AT&F
COMMAND
S Sync
Leased
Answer
(AT&F2)
S Async
Leased
Answer
(AT&F5)
S TMp
Control
(AT&F7)
S Async Dial
(AT&F0)
S Sync Dial
(AT&F1)
S Sync Leased
Originate
(AT&F4)
S Async Leased
Originate
(AT&F6)
S TMp Trib
(AT&F8)
S UNIX Dial
(AT&F3)
NOTE
ON POWER-UP, Active
(Saved) IS LOADED TO
Active (Operating)
Active (Operating)
CHANGES MADE USING ANY AT
COMMAND IMMEDIATELY AFFECT
MODEM OPERATION
Active (Saved)
(AT&W0)
Customer1
(AT&W1)
Customer2
(AT&W2)
NOTE
THE AT&W COMMAND IS
DISABLED IF THE Straps
When Disconnected
CONFIGURATION OPTION
IS SET TO Reload
Figure 5-2. AT Command Configuration Process