Paradyne 3910 User Manual

Page 210

AT Command Set and S-Registers

14-21

3910-A2-GN32-40

September 1998

Table 14-3

(7 of 13)

391x Series S-Registers

S-Register

DCP LCD

Command

Sequence

Description

S61

CT111 Rate Control. Register determines if CT111 Rate is disabled,
set for Fallback 1 or Fallback 2.

CT111 Rate allows the DTE to control modem rate via Pin 23 of the
EIA-232-D interface. This configuration option determines the effect of
the DTE Rate Control signal. It is only valid in Async Direct mode and
Synchronous mode. For proper operation, disable the V.32bis Autorate
and V.32bis Automode configuration options.

0 = Disable
1 = Fallback
2 = Fallback 2

The factory setting is Disable.

Configure\Edit\
DTE Interface

S62

V.25bis Coding. Register identifies to the modem the type of coding
used by the DTE while in V.25bis mode.

0 = ASCII
1 = EBCDIC

The factory setting is ASCII.

Configure\Edit\
DTE Dialer

S63

V.25bis Idle Character. Register identifies to the modem the type of
idle fill used by the DTE while in V.25bis mode.

0 = Mark
1 = Flag

The factory setting is Mark.

Configure\Edit\
DTE Dialer

S64

V.25bis New Line Character. Register identifies to the modem the type
of line terminator used by the DTE while in V.25bis mode.

0 =Carriage Return and Line Feed
1 =Carriage Return
2 =Line Feed

The factory setting is carriage return and line feed (CR + LF).

Configure\Edit\
DTE Dialer

S65

Line Current Disconnect. Register determines if the modem
disconnects if an 8-millisecond or 90-millisecond interruption in loop
current occurs.

0 = Enable (8msec)
1 = Enable (90msec)
2 = Disable

The factory setting is Enable (8msec).

Configure\Edit\
Line Dialer