Paradyne 3910 - Manual (Page 34)

COMSPHERE 3900 Series Modems
2-10 September 1998 3910-A2-GN32-40
Figure 2-2. Installing a Model 3911 Modem
2. At the front of the carrier, hold the modem vertically, with the latch on its faceplate in the
open position, and insert it into the top and bottom card guides of one of the slots
numbered 1–16 (Figure 2-2).
Slide the modem into the slot, aligning the modem with the rear connector plate, until the
backplane connector and DTE connector seat firmly into the back of the carrier. The
faceplate latch automatically closes as you push the modem into the carrier. To lock the
modem into the carrier, press the faceplate latch until a “click” is heard.
3. If the carrier is ON, the Power LED on the faceplate of the 3911 lights. After several
seconds the modem completes its power-up self-test, in which all faceplate LEDs light.
Return to the rear of the carrier and tighten the rear connector plate.
If the modem is to communicate with an installed SDCP, install the modem as described above and
perform the following steps:
1. Press the Select key on the SDCP. The cursor appears in the carrier selection entry.
2. Press the F1 (
" ) or F2 ( # ) key until the carrier number you want appears on the LCD.
The carrier number selection has a range of 1 to 8 since a single SDCP can control a
configuration of up to eight carriers. (This is only possible if the SDU is installed.)
3. Press the key to position the cursor on the slot selection entry.
4. Press the F1 (
" ) or F2 ( # ) key until the slot number you want (1–16) appears on the
LCD.