Paradyne 3910 User Manual
Page 200
AT Command Set and S-Registers
14-11
3910-A2-GN32-40
September 1998
Table 14-2
(7 of 10)
391x Series AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
&M
n and
&Q
n
Async/Sync Mode and DTE Dialer Type.
&M0, &Q0 Modem operates in Asynchronous mode and uses AT
Command protocol.
&M1, &Q1 Modem operates in Synchronous mode and uses AT
Command protocol.
&M2, &Q2 Modem operates in Synchronous mode and dials telephone
number stored in directory location 1 when DTR signal turns
OFF and then ON.
&M3, &Q3 Modem operates in Synchronous mode and uses AT
Command protocol.
Configure\Edit\
DTE Dialer
The &M2 and &Q2 commands disable the use of AT commands and
force the modem into Dumb mode. The only way to gain control of the
modem is via the DCP.
&R
n
RTS Action.
&R0
Standard RS232.
&R1
Ignores RTS.
&R2
Simulated Control Carrier.
&R3
Control Carrier.
Configure\Edit\
DTE Interface
&S
n
DSR Control.
&S0
Forced On.
&S1
Standard RS232.
&S2
Wink When Disconnect.
&S3
Follows DTR.
&S4
On Early.
&S5
Delay to DTE.
Configure\Edit\
DTE Interface
&T
n
Tests.
&T0
Abort. Stops any test in progress.
&T1
Local Analog Loop.
&T2
Pattern. Transmits and receives a 511 Bit Error Rate Test
(BERT).
&T3
Local Digital Loopback test.
&T4
Enables Receive Remote Loopback Response configuration
option.
&T5
Disables Receive Remote Loopback Response configuration
option.
&T6
Remote Digital Loopback test.
&T7
Remote Digital Loopback with Pattern.
&T8
Local Loopback with Pattern.
&T9
Self-Test.
Test
&T4 and &T5:
Configure\Edit\
Tests