Paradyne 3910 User Manual
Page 195
COMSPHERE 3900 Series Modems
14-6
September 1998
3910-A2-GN32-40
Table 14-2
(2 of 10)
391x Series AT Commands
AT
Command
DCP LCD
Command
Sequence
Description
D
n (cont.)
@
— Quiet answer. Wait for five seconds of silence after dialing
the number. If the silence is not detected, the modem
sends either a NO ANSWER result to the DTE.
!
— Hook flash. This causes the modem to go on-hook for 0.5
seconds then return to off-hook.
;
— Return to Command mode. Modem returns to Command
mode after dialing a number without disconnecting the call.
Space — Ignored by the dial string, can be included to enhance
readability.
–
— Ignored by the dial string, can be included to enhance
readability.
( )
— Ignored by the dial string, can be included to enhance
readability.
DS=
n
Dial Stored Number. Dials the number stored in Location
n (1–24). (To
store a telephone number, refer to the &
Zn=x command.)
Call Setup\Dial\
Dial Directory:
E
n
Command Character Echo.
E0
Disables echo to the DTE.
E1
Enables echo to the DTE.
Configure\Edit\
DTE Dialer
H
n
Hook Switch Control.
H0
Modem goes on-hook.
H1
Modem goes off-hook.
H0: Call Setup\
Disconnect or
Control\Remove
Make Busy
H1: Control\
Make Busy
I
n
Identification.
I
0
Displays product code — 144.
I
1
Displays 3-digit firmware revision number.
I
2
Performs an EPROM check.
Status\Identity
L
n
Speaker Volume.
L0
Selects low volume.
L1
Selects low volume.
L2
Selects medium volume.
L3
Selects high volume.
Control\Speaker
Configure\Edit\
Misc
M
n
Speaker On/Off.
M0
Speaker always OFF.
M1
Speaker ON until carrier signal is detected.
M2
Speaker always ON.
Control\Speaker
Configure\Edit\
Misc