Pitney Bowes DM300C - Manual (Page 93)

7-5
7 • System Options
SV62261 Rev. B
Setting the Normal Preset Timeout
The Normal Preset is a pre-defined set of values (postage, ad, ac-
count and so on) that your machine display au to mat i cal ly returns to
after a set period of time. You can set the amount of time the display
takes before it re verts to the Normal Preset.
1. Press
Menu .
2. Select "Setup".
3. Select "Time and Timeouts".
4. Select "Normal Preset Timeout".
Setting Sleep Mode Timeout
You can set the amount of time the machine waits before entering
"Sleep Mode". When the machine is in sleep mode, the display is
blank and you can't process mail. You "awaken" the machine by
pressing most keys on the control panel.
1. Press
Menu .
2. Select "Setup".
3. Select "Time and Timeouts".
4. Select "Sleep Mode"
5. Key in the amount of minutes (from 1-240) be fore the system
goes into Sleep Mode.
6. Select "Accept". The display returns to Time & Timeouts menu.
Standby Mode
–In order to reach the lowest use of power while still
plugged into an outlet, the switch on the back of the meter may be
toggled "off". Before resuming power to the meter, the switch will
need to be switched to the "on" position.
5. Key in the amount of minutes (from 1-240) you want the system
to wait be fore returning to the Normal Pre set. The default time is
64 minutes.
6. Select "Accept". The display returns to Time & Timeouts menu.
Normal Preset
Timeout
Enter Timeout
64
(1-240 minutes)
◄ Accept
Basic Options (cont'd)