Pitney Bowes DM300C - Manual (Page 3)

Declaration of Conformity According to FCC Rules Part 2,
Paragraph 2.1077
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation. Responsible party: Pitney Bowes, 1 Elmcroft
Rd., Stamford, CT 06926-0700.
Note for all models : This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These
limits are designed to provide reasonable protection against interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Changes or modifi cations to this equipment
not expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
Shielded I/O and USB cables must be used with this equipment to ensure
compliance with the limits. Use of unshielded cables is prohibited.
Industry Canada
This product meets the applicable Industry Canada technical specifi cations.
The Ringer Equivalence Number (REN) is an indication of the maximum
number of devices allowed to be connected to a telephone interface. The
Ringer Equivalence Number (REN) of this terminal equipment is 1.0. The
termination on an interface may consist of any combination of devices
subject only to the requirement that the sum of the RENs of all devices does
not exceed fi ve.
The abbreviation, IC, before the registration number signifi es that registration
was performed based on a Declaration of Conformity indicating that Industry
Canada technical specifi cations were met. It does not imply that Industry
Canada approved the equipment.