beautypg.com

Cleaning the shield and wick (dm400c), 12 • maintenance – Pitney Bowes DM300C User Manual

Page 159

background image

12-9

12 • Maintenance

SV62261 Rev. B

1.

Open the feeder access cover
and remove the moistener bottle.
Leave the moistener bottle out
until instructed to replace it.

2.

Remove the stripper blade and
brush assembly.

Cleaning the Shield and Wick (DM400c)

Wick

Shield

3.

Pull the moistener tank straight
out towards you. Gently lift the
tank up and out.

IMPORTANT:

The moistener tank may be full
of E-Z Seal

®

sealing solution.

If so, you can pour the solution
back into the moistener bottle,
or drain the tank into a recep-
tacle.

4.

Pull up and remove the shield
and wick from the moistener tank.

5.

Separate wick from the shield.
Clean the wick in plain water, and
rinse thoroughly.

i

NOTE:

Replace the wick

and shield if they cannot be
cleaned thoroughly.

6.

Place the wick back into the shield.

7.

Push the wick and shield back into moistener tank.

8.

Slide the tank back in place.

9.

Replace the stripper blade and brush assembly by pushing up
on the release lever and sliding the assembly back on its track
until it snaps into position.

10. Replace the moistener bottle and close the feeder access

cover.

Shield
and Wick

Pull here to remove tank

Moistener
Tank

Maintaining the Moistener (cont'd)