Paradyne 392xPLUS - Manual (Page 78)

DCP Operation
3-41 3920-A2-GN31-30 November 1996
F1
Control:
RemoveMakeBusy
F2 F3
Press any function key to select RemoveMakeBusy. The message Command Complete appears
on the LCD.
Service Line/Disconnect Service Line
The Service Line/Disconnect Service Line is only available in Models 3921-B1-001 and
3021-B1-011.
The Service Line function allows you to switch a specific Model 3921Plus installed in a
COMSPHERE 3000 Series Carrier from normal leased or dial operation to service-line operation.
This switch only places the modem on the service line. For a connection to be established, you
must still use the normal dialing methods as described earlier in this chapter in the Call Setup
Branch section.
A service line is an extra dial line connected to a COMSPHERE 3000 Series Carrier. This line is
normally shared by up to four Model 3921Plus multiport or eight singleport modems installed in
either Slots 1–8 or Slots 9–16. However, by daisy chaining the service-line connector of one
Network Interface Module (NIM) to the service line of another NIM installed in the same carrier,
you can permit eight multiport or sixteen singleport modems to share one service line. The service
line can also be extended to other carriers in a cabinet. For more information on daisy chaining
NIMs to the service line, refer to the COMSPHERE 3000 Series Carrier, Installation Manual.
A service line is ideal for a dial backup of Model 3921Plus modems operating on leased lines.
Remember that a service line can back up only one failed leased line at a time.
To enable service line from the Control branch, make the following selections:
Press the key until Service Line appears.
F1
Control:
Service_Line
F2 F3
Press F1 (Service_Line) to switch the modem from its normal dial line to the service line.
F1
Service_Line
Command Complete
F2 F3
The message Command Complete appears. Now, when the modem places a call, instead of using
the dial, the call is placed on the service line.