Paradyne 392xPLUS - Manual (Page 207)

COMSPHERE 392xPlus Modems
5-22 November 1996 3920-A2-GN31-30
Table 5-3
(7 of 12)
392x Plus S-Registers
S-Register
DCP LCD
Command
Sequence
Description
S61 CT111 Rate Control. Register determines if CT111 Rate is disabled, set for
Fallback 1 or Fallback 2.
CT111 Rate allows the DTE to control modem rate via Pin 23 of the EIA-232-D
interface. This configuration option determines the effect of the DTE Rate
Control signal. It is only valid in Async Direct mode and Synchronous mode.
For proper operation, disable the V.32bis Autorate and V.32bis Automode
configuration options.
Register has the following values:
0 = Disable
1 = Fallback
2 = Fallback 2
The factory setting is Disable.
Configure\Edit\
DTE Interface
S62 V.25bis Coding. Register identifies to the modem the type of coding used by
the DTE while in V.25bis mode.
Register has the following values:
0 = ASCII
1 = EBCDIC
The factory setting is ASCII.
Configure\Edit\
DTE Dialer
S63 V.25bis Idle Character. Register identifies to the modem the type of idle fill
used by the DTE while in V.25bis mode.
Register has the following values:
0 = Mark
1 = Flag
The factory setting is Mark.
Configure\Edit\
DTE Dialer
S64 V.25bis New Line Character. Register identifies to the modem the type of line
terminator used by the DTE while in V.25bis mode.
Register has the following values:
0 = Carriage Return and Line Feed
1 = Carriage Return
2 = Line Feed
The factory setting is carriage return and line feed (CR + LF).
Configure\Edit\
DTE Dialer
S65 Line Current Disconnect. Register determines if the modem disconnects if an
8-millisecond or 90-millisecond interruption in loop current occurs.
Register has the following values:
0 = Enable (8msec)
1 = Enable (90msec)
2 = Disable
The factory setting is Enable (8msec).
Configure\Edit\
Line Dialer