Paradyne 392xPLUS - Manual (Page 217)

B-1 3920-A2-GN31-30 November 1996
Troubleshooting
Overview B-1 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Overview
This appendix points out basic problems that can occur when operating a 392xPlus modem. Use
Tables B-1 through B-6 to check out these problems. If you are having data communication
difficulties, such as periodic character loss, random errors, or constant format errors, use the
loopback tests described in the Test section of Chapter 4. With these tests you can usually isolate
the fault in your system by using the process of elimination. If problems continue to occur,
contact your service representative.
Table B-1
Modem Health
Symptom Action
The modem did not pass the
power-up self-test. Contact your service representative.
The power LED does not light or the
LCD does not display information. Make sure the modem’s ON/OFF switch is in the ON position.
Make sure the power supply is connected to the dc power receptacle on the
modem.
If the Power LED and/or LCD do not operate, contact your service
representative.
A problem is suspected after the
power-up self-test. Perform a self-test via the modem’s DCP or type AT&T9 if using AT commands.
Perform a local analog loopback with a Pattern test. If the modem consistently
registers errors, contact your service representative.
If the modem passes the above tests and a problem still exists, then the
problem is probably not with your modem.
B