Paradyne 392xPLUS - Manual (Page 56)

DCP Operation
3-19 3920-A2-GN31-30 November 1996
Table 3-6
(2 of 3)
Health and Status Messages
Type Indicates Message
Status Subtree Truncate Downstream health and status information has been truncated because it
overflowed system limits. There is a large amount of health and status
information in the subnetwork.
Test Mode The modem or an upstream device is running a disruptive test.
Disabled The modem’s DTE port has been disabled.
On Dial Backup The modem is operating in Dial Backup mode.
FW Downloading A firmware download is in progress.
Primary Line Good The modem is currently operating on the 2-wire backup facility, the Lease
Lookback option is enabled, and the modem detects continuity on the primary
4-wire leased lines.
Backup Line Bad The modem is currently operating on the primary 4-wire leased facility with
2-wire leased lines selected as the backup facility, the BackupLineCheck
configuration option is enabled, and the modem detects continuity on the 2-wire
backup leased lines.
Data Blocked The modem’s data path is blocked.
On Lease Backup The modem is operating in 2-wire Leased Backup mode.
PSTN Test Fail The modem failed either the Dial Tone Detection or the Ring Tone Detection
portion of the Call Test command.
Dial Make Busy Mode The modem is in a Make Busy condition Dial Make Busy Mode The modem is in a Make Busy condition.
Service Line (Model 3921 Plus only) The modem installed in a COMSPHERE 3000 Series
Carrier has been switched to a service line.
Short Hold Time The modem’s dial hold time has been shortened.
Non-Answering The modem is in a non-answering mode.
Thresh* RSL High Threshd The received signal level (RSL) has exceeded the upper threshold.
RSL Low Threshld The RSL is less than the lower threshold.
SNR Threshold The signal-to-noise ratio has exceeded the threshold.
Non-linear Dist The non-linear distortion exceeded the threshold.
Retrains The number of retrains exceeded the threshold.
Signal Quality The signal quality is less than the threshold.
Far Echo Threshd The far end echo level exceeded the threshold.
Near Echo Thresh The near end echo level exceeded the threshold.
Phase Jitter The phase jitter level exceeded the threshold.
Phase Hit Thresh The number of phase hits has exceeded the threshold.
Impulses Hit The number of impulse hits exceeded the threshold.
Gain Hit Threshld The number of gain hits exceeded the threshold.
Drop Outs Thresh The number of drop outs exceeded the threshold.
Frequency Offset The frequency offset level exceeded the threshold.
* Not supported in every modulation.