Printronix L5520 - Manual (Page 85)

Paper Control Menu
85
For example, a form length parameter setting of 10 inches
results in a paper length setting of 10 inches, as 10 inches is
within the valid range for form length and paper length
parameters. A form length setting of 24 inches results in a
paper length setting of 12 inches, as 24 is above the valid
range. A form length setting of five inches results in a paper
length setting of 10 inches, as five is below the valid range.
• Inch Select/Length in Inches. This allows you to set the paper
length in inches. The range is 7.0 to 20.0 inches, in one-half
inch increments. The default is 11.0 inches.
• 6 LPI Select/Length at 6LPI. This menu selection allows you to
set the paper length in lines. The range is from 42 to 120 lines,
in 1 line increments. The default is 66 lines.
Fanfold Output
The Fanfold Output option specifies the paper path through the
stacker. You can select either into the stacker (default) or to bypass
the stacker.
Burst on Eject
Burst on Eject allows you to use roll-feed paper that cannot be cut
(separated) or parked (backed out of the print engine).
• With fanfold paper, whenever you change the page size or
press the PAGE EJECT key, the printer automatically
separates the currently loaded paper at the perforation and
backs the unprinted paper out of the engine.
• With roll-feed paper, the printer cannot separate the paper
because there are no perforations. Burst on Eject must be set
to Disable. The perforations separator is not used, and paper is
never rolled back out of the engine. If you need to remove the
paper before the entire roll is used, you must remove it
manually.