Printronix L5520 - Manual (Page 111)

Flash Messages
111
FILE EXISTS
ENABLE OVERWRITE The “Overwrite Files” menu
selection is set to Disable, and
you attempted to write to an
existing file in the flash file
system. Enable the “Overwrite
Files” menu selection.
Then, try the operation
again.
FILE SYS FULL
ADD FLASH The file to be stored in the flash
file system is too big for the
flash, even if you were to delete
files from the file system and
optimize the file system. Have your service
provider add more DC
flash memory to the
controller board, then
optimize the flash file
system. Try the
operation again.
FILE SYS FULL
DELETE FILES The file to be stored in the flash
file system would either:
1. exceed the available free
space in the file system; or
2. exceed the maximum
number of files (144) that
the file system can hold.
Delete one or more files
from the flash file
system. Then, optimize
the flash file system .
Try the operation again.
FILE SYS FULL
OPTIMIZE&REBOOT There is insufficient free space
in the flash file system to do the
requested operation, and there
are existing file(s) in the flash
file system that have been
marked for deletion. Optimize the flash file
system to delete the
marked files, freeing the
space they were
occupying. Then, try the
operation again.
FILE SYS INVALID
OPTIMIZE&REBOOT The flash file system is either
invalid (corrupt) or not present.
The cause can be either a
program error or a hardware
failure of the DC flash memory. Reboot the printer
several times. If the
message persists,
replace the DC flash
memory on the
controller board, or
contact your service
provider.
Table 2. Flash Messages